HAMAMATSU-NISHI P.O. BOX 1, 432-8611 HAMAMATSU, JAPAN.
MOTORCYCLE
DATE:
May 16, 2006
PAGE
: 8
OF
13
3. SERVICING
CLUTCH AIR BLEEDING
[Page: 43, 44 Paragraph: 2]
Disconnect the regulator/rectifier lead wire coupler.
A: Coupler
FRONT BRAKE LEVER
[Page: 45, 46 Paragraph: 1]
Make sure the front brake lever position is correct.
The standard setting for this motorcycle is as indicated
in the table below.
A: Adjuster
THROTTLE CABLE [Page: 45, 46 Paragraph: 3, 4]
This motorcycle has a twin throttle cable system.
Cable
A is for pulling cable and cable
B is for return-
ing.
Check the throttle cable play at the throttle grip.
Throttle cable play: 2.0–4.0 mm
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut
C.
2. Turn the adjuster
D in or out until the correct play.
3. Tighten the lock nut
C while holding the adjuster
D.
#
Standard setting 3
2.0–4.0 mm
After the adjustment is completed, check that
handlebar movement does not raise the engine
idle speed and that the throttle grip returns
smoothly and automatically.
To Next Page
Loading...
