HAMAMATSU-NISHI P.O. BOX 1, 432-8611 HAMAMATSU, JAPAN.
MOTORCYCLE
DATE:
May 16, 2006
PAGE
: 6
OF
13
LEFT
Clamp the left handlebar switch wiring harness, clutch
hose union or clutch hose with straps as shown in the
photograph.
A: Strap L:140 mm
B: Left switch wiring harness
C: Clutch hose union
D: Clutch hose
Fit the cable clip to the throttle cables as shown in the
photograph.
A: Clip
B: Throttle cable (pulling cable)
C: Throttle cable (returning cable)
HANDLEBAR BALANCER
[Page: 15, 16 Paragraph: 4]
Assemble the handlebar balancer parts as shown.
A: 6 × 120 mm screw
B: Balancer weight
C: Flange rubber cushion
D: Spacer L:50.0 mm
E: Washer OD:16.0 mm ID:6.5 mm T:4.0 mm
F: Rubber cushion
G: 6 mm spacer nut
REFLEX REFLECTOR (FOR LIMITED MARKET)
[Page: 25, 26 Paragraph: 4]
Install the reflex reflectors to the front fork leg.
A: Reflex reflector
B: Reflex reflector stay
C: Washer OD:12.0 mm ID:5.5 mm
NOTE:
Cut the remaining of the strap as shown in the
photograph.
OUTSIDE
300 mm
UP
When installing the reflex reflectors to the front
fork leg, tighten the reflex reflector stay.
To Next Page
Loading...
