SV106 user's manual
1.
INTRODUCTION 7
1.1.
SV106 main features 7
1.2.
Accessories included 8
1.3.
Accessories available 8
2.
MANUAL CONTROL OF THE INSTRUMENT 10
2.1
Control push-buttons on the front panel 10
2.2
Input and output sockets of the instrument 13
3.
SETTING THE INSTRUMENT 15
3.1.
Basics of the instrument’s control 15
3.2.
Powering of the instrument 18
3.3.
Initial Setup of the instrument 18
3.4.
Icons description 19
3.5.
Memory organisation 20
4.
FUNCTIONS OF THE INSTRUMENT – Function 23
4.1.
Measurement functions of the instrument - Measurement Function 23
4.2.
Instrument’s calibration – Calibration 23
4.2.1.
Downloading and uploading TEDS data – TEDS 24
4.2.2.
Calibration of the instrument channels – Channel x 25
4.2.3.
In-situ System Check 25
4.2.4.
Calibration by transducer's sensitivity – Calibr. By Sensitivity 26
4.2.5.
Calibration by measurement – Calibr. By Measurement 27
4.2.6.
History of the calibrations – Calibration History 28
4.2.7.
Clear calibration records - Clear Calibr. History 29
4.2.8.
Contact force sensor calibration - Force 29
5.
MEASUREMENT PARAMETERS SETTING – Measurement 32
5.1
Selection of measurement parameters - General Settings 32
5.2
Setting the parameters for dose measurements – HAV/WBV Dosimeter 35
5.3
Setting parameters in a channels – Channels Setup 36
5.3.1
Assignment channels for the accelerometer axis - Channel/Axis Mapping 37
5.3.2
Setting parameters for channels – Channel x 37
5.4
Setting the vector parameters – Vectors Setup 38
5.5
Setting the data logging functionality – Data Logging 39
5.6
The results history logging 39
5.6.1
Data logger programming – Logger Setup 40
5.6.2
Results selection – Logger Results 41
5.6.3
Logger trigger parameters setup – Logger Trigger 43
5.6.4
Event recording setup – Event Recording 45
5.6.5
The marker setup – Marker Setup 46
To Next Page
Loading...
Need help?
General
