SV106 user's manual
8.7
Checking the specification of the instrument - Unit Label 77
9.
AUXILIARY SETTINGS – Auxiliary Setup 79
9.4.
Setting the language of the user interface – Language 79
9.5.
Return to the factory settings – Factory Settings 79
9.6.
Locking the menu - Instrument Lock 80
9.7.
Setting the scope of instrument's functions — Instrument Mode 80
9.8.
Reference signal in vibration measurements - Reference Levels 81
9.9.
User filter setting – User Filters 81
9.10.
Selection of the Vibration units - Vibration Units 82
9.11.
Warnings selection – Warnings 82
10.
1/1 AND 1/3 OCTAVE ANALYSER 84
10.1.
Selection of 1/1 Octave or 1/3 Octave analysis mode 84
10.2.
Setting the parameters of 1/1 Octave and 1/3 Octave analysis 84
10.3.
Saving of 1/1 Octave and 1/3 Octave analysis results in the logger’s file - Logger
Results 84
10.4.
Selection of 1/1 Octave and 1/3 Octave bandpass results as triggering source 85
10.5.
Display options in 1/1 Octave and 1/3 Octave analysis mode 85
10.6.
Presentation of 1/1 Octave and 1/3 Octave analysis results 86
10.7.
Setting the scale of the spectrum results presentation – Spectrum Scale 87
10.8.
Setting parameters of the spectrum presentation - Spectrum View 88
10.9.
Selection of channels for presentation – Multichannel View 89
10.10.
Setting parameters for total values – Total Values 89
10.11.
Setting user filter coefficients for 1/1 Octave and 1/3 Octave analysis – User Filters 90
11.
DOSIMETER FUNCTION 92
11.1.
Setting parameters for dose measurements – HAV/WBV Dosimeter 92
11.2.
Setting parameters for channels – Channel x 93
11.3.
Dosimeter presentation mode 93
11.4.
Calculation of hand-arm and whole-body daily results – Calculator 94
To Next Page
Loading...
Need help?
General
