CONTENTS
1. INTRODUCTION 6
1.1. SV106 main features 6
1.2. Accessories included 7
1.3. Accessories available 7
1.4. Software options 7
1.5. General Information 8
2. MANUAL CONTROL OF THE INSTRUMENT 9
2.1 Control push-buttons on the front panel 9
2.2 Input and output sockets of the instrument 12
3. SETTING THE INSTRUMENT 13
3.1. Basics of the instrument’s control 13
3.2. Powering of the instrument 15
3.3. Initial Setup of the instrument 16
3.4. Icons description 17
3.5. Data saving 18
3.6. Files downloading and uploading 22
3.7. Activation of the optional functions 22
4. FUNCTIONS OF THE INSTRUMENT – Function 23
4.1. Measurement functions of the instrument - Measurement Function 23
4.2. Instrument’s calibration – Calibration 24
4.2.1. Downloading and uploading TEDS data – TEDS 24
4.2.2. Calibration of the instrument channels – Channel x 25
4.2.3. In-situ System Check 25
4.2.4. Calibration by transducer's sensitivity – Calibr. By Sensitivity 26
4.2.5. Calibration by measurement – Calibr. By Measurement 27
4.2.6. History of the calibrations – Calibration History 28
4.2.7. Clear calibration records - Clear Calibr. History 28
4.2.8. Contact force sensor calibration - Force 29
5. MEASUREMENT PARAMETERS SETTING – Measurement 31
5.1 Selection of measurement parameters - General Settings 31
5.2 Setting the parameters for dose measurements – HAV/WBV Dosimeter 34
5.3 Setting parameters for channels – Channels Setup 35
5.3.1 Assignment channels for accelerometer axis - Channel/Axis Mapping 36
5.3.2 Setting parameters for channels – Channel x 36
5.4 Setting the vector parameters – Vectors Setup 37
5.5 Setting the data logging functionality – Data Logging 37
5.6 The results history logging 38
5.6.1 Data logger programming – Logger Setup 38
5.6.2 Results selection – Logger Results 39
To Next Page
Loading...
Need help?
General
