• triaxial accelerometer,
Hand-Arm, direct fixing to
the tool – SV 150
• triaxial accelerometer for
Whole-Body
measurements (MEMS
type) - SV 38V
• triaxial accelerometer for
building/ground vibration -
SV 84
• triaxial accelerometer for
measurements on vehicle
floor - SV 151
Both accelerometers can be a part
of the SV 207B kit that includes
metal mounting base.
All accelerometers have LEMO 5-pin connectors: six
channels IEPE type or Direct and two channels for force
transducers, which can be attached to the one of input
connectors of the instrument.
Note: The TEDS data (accelerometer serial number and calibration factor) for the accelerometer
will automatically be downloaded to the SV 106A internal memory.
12.3. Resetting the instrument
• SYSTEM RESET: internal software reset clears any setup configuration, and brings back the default
factory settings. See Factory Settings (path: <Menu> / Auxiliary Setup).
• HARDWARE RESET: internal hardware reset, no user data is changed. Make sure the battery is not
exhausted, and the unit is turned off. Hold down the <Alt> and <Start/Stop> push-buttons for more
than 15 seconds, and then release it. Turn on the instrument as usually.
To Next Page
Loading...
Need help?
General
