9.2. Return to the factory settings – Factory Settings 73
9.3. Setting the scope of instrument's functions — Instrument Mode 74
9.4. Reference signal in vibration measurements - Reference Levels 75
9.5. User filter setting – User Filters 75
9.6. Selection of the Vibration units - Vibration Units 75
9.7. Warnings selection – Warnings 76
10. 1/1 AND 1/3 OCTAVE ANALYSER 77
10.1. Selection of 1/1 Octave or 1/3 Octave analysis mode 77
10.2. Setting the parameters of 1/1 Octave and 1/3 Octave analysis 77
10.3. Saving of 1/1 Octave and 1/3 Octave analysis results in the logger’s file - Logger Results
78
10.4. Selection of 1/1 Octave and 1/3 Octave bandpass results as triggering source 78
10.5. Display options in 1/1 Octave and 1/3 Octave analysis mode 78
10.6. Presentation of 1/1 Octave and 1/3 Octave analysis results 79
10.7. Setting the scale of the spectrum results presentation – Spectrum Scale 80
10.8. Setting parameters of the spectrum presentation - Spectrum View 81
10.9. Selection of channels for presentation – Multichannel View 82
10.10. Setting parameters for total values – Total Values 82
10.11. Setting user filter coefficients for 1/1 Octave and 1/3 Octave analysis – User Filters 82
11. DOSIMETER FUNCTION 84
11.1. Setting parameters for dose measurements – HAV/WBV Dosimeter 84
11.2. Setting parameters for channels – Channel x 85
11.3. Dosimeter presentation mode 85
11.4. Calculation of hand-arm and whole-body daily results – Calculator 86
12. MAINTENANCE 89
12.1. Powering and charging 89
12.2. Transducers 89
12.3. Resetting the instrument 90
12.4. Firmware upgrade 91
12.5. Storing the instrument 91
12.6. Transportation and carrying 91
12.7. Cleaning 91
12.8. Troubleshooting 91
APPENDIXES
A. REMOTE CONTROL
B. DATA FILE STRUCTURES
C. TECHNICAL SPECIFICATIONS
D. DEFINITIONS AND FORMULAE OF MEASURED VALUES
To Next Page
Loading...
Need help?
General
