19
4.7 ADVANCE MENU ___DETECTION
4.7 ADVANCE MENU ___DETECTION
Move the cursor to the “DETECTION”, and press ”ENTER”, then the screen will show the
following options.
DETECTION
DETECTION
TITLE DET AREA LS SS TS RE ALARM
01 ON SETUP 07 03 02 10 OFF
02 ON SETUP 07 03 02 10 LOW
03 ON SETUP 07 03 02 10 HIGH
04 ON SETUP 07 03 02 10 OFF
05 ON SETUP 07 03 02 10 OFF
06 ON SETUP 07 03 02 10 OFF
07 ON SETUP 07 03 02 10 OFF
08 ON SETUP 07 03 02 10 OFF
PREV NEXT
DETECTION
DETECTION
DETECTION SETUP
DETECTION TIMER
1) DETECTION SETUP:
a) TITLE:
Show the title of each channel of the camera.
b) DET:
Select “ON” to activate the motion detect function of each channel.
Select “OFF” to inactivate the motion detect function of each channel.
c) AREA:
Press the “ENTER” button to set detection area.
Pink blocks represent the area that is not being detected. While the transparent
blocks is the area that is under detection.
Press “ENTER” to confirm the
start area
Press ◄ or ► to choose the
width of the area
Press ◄ or ► to choose the
height of the area, and press
“ENTER” again to confirm.
Multi-detected area
Press “－” to turn all area
under detection
Press “＋” to turn all area not
to be detected
Take 16CH as an example
Take 16CH as an example
To Next Page
Loading...
