Swann 16CH - Appendix #1 Install the HDD; HDD Installation Guide

APPENDIX #1
APPENDIX #1
APPENDIX #1
APPENDIX #1
–
–
INSTALL THE HDD
INSTALL THE HDD
49
1) Open the upper cover of the DVR and screw out the bracket.
2) Screw HDD to the HDD bracket.
3) Connect the HDD to power connector and IDE BUS (make sure to align the
HDD precisely to the pin connection).
4) Close the upper cover of the DVR.
3
3
8
8
~
1
1
2
2
~
9
9
14
14
~
16CH / 8CH
16CH (D) / 8CH (D) / 4CH (D)
Carefully following the steps to ensure correct installation.
*** Note: If you want to install two HDDs, please set one HDD to “Master Mode” or “Single
Mode”, and the other one to “Slave Mode”. ***