Swann 16CH - Connect to Ap Via Ie Browser

5.7 CONNECT TO AP VIA IE BROWSER
5.7 CONNECT TO AP VIA IE BROWSER
46
Step 1
Step 1: Type in IP address into the URL address box and press enter.
Then you’ll see the following page.
Step 2
Step 2: Install JAVA program with attached CD (AP Disk).
Or download JAVA program on the website.
NOTE:
NOTE: Users can update the JAVA program from the website.
Download AP
Download JAVA
Note:
Note:
If the TCP port number is not 80, see the example below.
IP address: 60.121.46.236 ; Port number: 888
Æ Key in “60.121.46.236 :888” into the URL address box and press enter.
The DVR can be viewed over the network with a web browser. Please install licensed
software AP first.
*** This function is suitable in both Windows 2000 and Windows X
*** This function is suitable in both Windows 2000 and Windows X
P ***
P ***
Step 3
Step 3
: After installation, please type the IP address of your DVR into the URL address box
and press “enter”. Then you’ll see the login page. Key in the “username” and “password”.
Then you’ll see the following page.
Same as the AP operation.
Same as the AP operation.
Please refer to
Please refer to
“
“
Section 6.6
Section 6.6
Licensed Software AP
Licensed Software AP
”
”
.
.
Change Image Quality
Change Image Quality
Change Resolution
Change Resolution
PTZ
PTZ
To set the display position of the image
To set the display position of the image
(LT: Upper Left; LD: Lower Left; RT: Upper Right; Lower Right)
(LT: Upper Left; LD: Lower Left; RT: Upper Right; Lower Right)