Swann 16CH - Page 26

23
4.10 ADVANCE MENU ___REMOTE
4.10 ADVANCE MENU ___REMOTE
Move the cursor to “REMOTE”, and press ”ENTER”, then the screen will show the
following options.
REMOTE
REMOTE
TITLE DEVICE ID PROTOCOL RATE
01 PTZ 001 P - D 02400
02 CAMERA 002 NORMAL 02400
03 CAMERA 003 NORMAL 02400
04 CAMERA 004 NORMAL 02400
05 CAMERA 005 NORMAL 02400
06 CAMERA 006 NORMAL 02400
07 CAMERA 007 NORMAL 02400
08 CAMERA 008 NORMAL 02400
PREV NEXT
1) TITLE:
Title of each camera.
2) DEVICE:
Select to control normal camera or PTZ camera for each channel.
3) ID:
Set the ID number (0 ~ 255) as same as the ID of each device.
4) PROTOCOL:
Select NORMAL (our protocol) or PELCO-D protocol.
5) RATE:
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600).
PTZ Control:
PTZ Control:
1)
Device
Device: Our own brand PTZ / Pelco-D protocol PTZ
2)
Connection
Connection: Refer to rear panel / Refer to PIN configuration
3)
Control Mode
Control Mode: Refer to front panel / Refer to IR remote control manual
4)
Detailed Instructions
Detailed Instructions: Refer to PTZ manual
Take 16CH as an example
Take 16CH as an example