What to do if Swann 4 CH Digital Video Recorder DVR is not working when I press any button?
If your Swann DVR isn't responding to button presses, check if it is under Key Lock mode. To exit Key Lock mode, press the "MENU" and "ENTER" buttons simultaneously.
What to do if my Swann 4 CH Digital Video Recorder has no power?
If your Swann DVR is not powering on, check the power cord connections to make sure they are secure. Also, confirm that the power outlet is working.
How to switch between NTSC & PAL systems on Swann 4 CH Digital Video Recorder DVR?
To switch between NTSC and PAL systems on your Swann DVR, press “POWER” + “FF” to switch to NTSC, and press “POWER” + “REW” to switch to PAL.
Lists essential safety instructions for operating the DVR safely and correctly, including electrical and environmental considerations.
Step-by-step instructions for physically installing and connecting the DVR hardware, including HDD setup.
Initial steps for powering on, booting, and setting up the DVR for the first time.
Common issues and their solutions for diagnosing and fixing DVR problems.
Provides step-by-step instructions for installing a hard disk drive into the DVR.
To Next Page
General