Swann Advanced-Series 8 Channel DVR H.264 - Page 63

61
Setting up Cruise Mode
To setup CRUISE MODE, you’ll need to dene “POINTS”
for each channel with a PTZ camera you want to
“cruise”. A POINT is one place that the camera needs to
move to on its loop.
• Move the camera to the desired position using the
arrows.
• Hit the button.
• The point will be saved. Its name will be one digit
higher than the previous point.
• For easy cruise setup, dene your points in the same
order as you want the camera to move through
them.
The button will take the camera back to a pre-
dened point. The button will remove all your de-
ned points.
When you’ve set your points, select then .
• To start cruise mode, select START CRUISE from the
pop-up menu.
• To stop cruise mode, select STOP CRUISE from the
same menu.
Remember: Before Cruise Mode will work, you’ll need
to have enabled the PTZ Conguration menu. See page
46.
9. SELECTED PRESET POINT: The current preset point being dened/edited.
10. STOP TIME: How long the camera will pause at each preset point when using
CRUISE MODE.
11. GOTO: Moves the camera to the selected preset point.
12. DEFINE: Saves the current position of the camera as a preset point.
13. ERASE: Deletes the selected preset point.
14. SAVE: Saves changes.
15. EXIT: Leaves the PTZ SETUP menu.