Search: The Playback Interface
The Playback interface is quite similar to a computer’s media
player, or to the on-screen display of a DVD/Blu-ray player.
Most of the controls are quite straight forward, and operate in
the same way as a standard media player.
Current Position: A basic progress meter. You can click to
move the current position icon to quickly scan through video
events.
Volume Control: Alters the output volume of playback.
Cut & Copy: Used to mark a Start Point and End Point for
incident backups. Press Cut to mark an start point, and press
Cut again to mark an end point. Press Copy to make a backup
of everything in between. For more detail of the Cut & Copy
commands, see “Specific Incident Backup” on page 31 for
more details.
Rewind: Reverses the footage.
Play: Plays footage at normal speed.
Pause / Step: Pauses playback but retains still images on-
screen. Subsequent presses will move a single frame forward
in the video. This will usually be 1/30th (NTSC) or 1/25th (PAL)
of a second.
Fast-Forward: Speeds up playback.
Slow: Plays back footage at reduced speed. Press multiple
times to further reduce the speed: 1/2 speed, 1/4 speed, 1/8th
speed, 1/16th speed and so on.
Recording Type: Whether the video being played back was
recorded under normal recording (blue) or based on motion
event (red).
Hide Console: Maximizes the area on-screen for playing back
your footage by hiding the on-screen controls.
Exit Playback: Leaves the playback interface and returns to
the live viewing mode.
Digital Zoom menu:
Right-click on the display and click to show
the
Digital Zoom control panel.
Click:
to zoom in, to zoom out, to draw a box over an
area of the video that you want to zoom in on,
to restore
zoom back to default setting,
to exit Digital Zoom mode.
Note: While you’re playing back footage, the NVR continues to
monitor and record normally.
To Next Page
Loading...
