Contents
1. General 3
1.1 Intended utilisation 3
1.2 Hazards 3
2. Safety 4
2.1 Safety regulations 4
2.2 Safety instructions 4
3. Storage and Transport 5
3.1 Storage, intermediate storage 5
3.2 Installation-site transport 5
4. Installation 7
4.1 Foundation/Base frame 7
4.2 Equipment installation 7
4.3 Structure-borne noise insulation 7
4.4 Potential equalisation/Grounding 7
4.5 Frost protection 8
4.6 Equipment attachment 8
4.7 Fan installation/removal 8
4.8 Motor protection 9
4.9 Electrical connection 9
4.9.1 Connecting three-phase motors 10
4.9.2 Wiring with frequency converters 14
4.10 Pocket type filter
15
4.11 Water coils
15
4.12 Droplet separator
15
4.13 Steam heater
15
4.14 Refrigerant line
15
4.15 Air ducts
15
4.16 Drainage
16
4.17 Gas surface burner
16
4.18 Direct lighted burner
16
5. Commissioning & Operation
17
5.1 Housing/Units
17
5.2 Fan
17
5.3 Belt drive (fan)
18
5.4 Sound attenuator
18
5.5 Filter
18
5.6 Water coils
19
5.7 Droplet seperator
20
5.8 Cooling system
20
5.9 Humidifier
21
5.10 Louver dampers
21
5.11 Rotary heat exchanger
22
5.12 Plate heat exchanger
22
5.13 Coil heat exchanger
22
5.14 Direct lighted burner
23
5.15 Gas surface burner
23
5.16 Cleaning
24
5.17 Control equipment
24
6 Decommissioning
25
6.1 Decommissioning
25
6.2 Dismantling and disposal
25
7 Emergency Measures
25
7.1 Fire prevention
25
7.2 Leakage of harmful substances
25
8 Explosion Protection
26
8.1 Service, maintenance and repair
26
8.2 Identification marking
26
8.3 Avoidance of ignition sources
26
9. Maintenance
27
This document was originally written in German.
EN.SILVER.110322
The company reserves the right to make design changes without prior notice.
2 www.swegon.com