2.1 Safety regulations
The climate control unit has been manufactured accord-
ing to the latest state of technology and approved safety
related regulations. None-the-less, hazard to life and limb
of the user or a third party, degradation of the equipment
and other material assets can arise due to improper utilisa-
tion or utilisation, for which the unit was not intended.
The unit may be operated only in a technically faultless
condition for its intended purpose, with an awareness
towards safety and potential hazards. Faults, which can
diminish operational safety, must be immediately rectified.
Installation work and commissioning may be carried out
exclusively by trained specialist personnel. The manufac-
turer’s warranty no longer applies if servicing is not prop-
erly carried out.
Fundamental to the warranty is also the completion of a
service contract with a qualified specialist company and its
verification by means of protocol documentation.
The operating Instructions must be read carefully prior to
installation and commissioning by installers, commission-
ing and operating personal. Only though adherence to this
manual can mistakes be avoided and fault-free operation
be achieved.
If arbitrary or unauthorised modifications or alterations are
undertaken on the equipment, the manufacturer’s war-
ranty is no longer valid.
The equipment is part of an airhandling system and may
be operated only after installation of the entire system.
2. Safety
2.2 Safety instructions
In order to avoid overheating damage to the system, the
steam heat exchanger should be operated only with the
ventilator running. When using the temperature limiter,
it must be observed that the temperature monitor is
adjusted ca. 5K lower than the safety temperature limiter.
The allowable pressure level for the heat exchanger and
associated piping may not be exceeded.
Accessibility to safety relevant components must be guar-
anteed over the entire serviceable life.
The electrical connection, as well as the servicing of elec-
trical components, may be carried out only by authorized
specialist in accordance to national regulations.
In conjunction with the initial connection and subsequent
inspections, the electrical connection bolts must be re-
tightened.
Special regulations, such as building oversight guidelines
for fire protection regulations related to air handling
systems, are compulsorily prescribed and, for this reason,
must absolutely be adhered to.
Refrigerant (odourless and tasteless) suppresses atmos-
pheric oxygen and can lead to asphyxiation. In the
event of a refrigerant leak, the machine room should be
accessed only with breathing protection equipment.
When disposing of refrigerant, environmental protection
regulations should be observed.
When the equipment is functioning in an explosion hazard
atmosphere, please observe Chapter 8!
EN.SILVER.110322
The company reserves the right to make design changes without prior notice.
4 www.swegon.com
To Next Page
Loading...
