Swegon SILVER Series - Component Installation and Attachment; Frost Protection; Equipment Attachment

• The bolts can then be secured. The modules should be
connected with the threaded connections.
• For larger equipment depth, the modules should be
connected with additional centring threaded connec-
tions.
• For large pieces of equipment, the square frames
should be additionally secured with connecting clamps.
• The section points of the outer equipment components
are to be subsequently sealed with the sealing com-
pound as provided.
4.5 Frost protection
Frost protection capillary tubing must be evenly stretched
over the entire exchanger surface at the air outlet.
Care must be taken so that frost protection capillary
tubing is not buckled or damaged.
4.6 Equipment attachment
Installation material is provided. This is found in the
marked equipment modules.
In order to connect the equipment components, the fol-
lowing tasks are to be carried out:
• Self adhesive sealant is to be attached per section point
to the profile frames in two tracks on the equipment
component.
• Winch the equipment components together until they
are positioned exactly together
• Do not pull the equipment components together with
the attachment bolts. Deformation hazard!
EN.SILVER.110322
The company reserves the right to make design changes without prior notice.
8 www.swegon.com