Swegon SILVER Series - Page 29

Activity Action
Months
1 3 6 12 24
10 Rotary heat exchanger
10.1
Check rotation surface for air-side contamination
and damage
Adjust gasket seals, cleaning, repair
x
10.2
Application oriented cleaning
(e.g. usage of compressed air or grease-
dissolving cleaning agents)
x
10.3
Check sealing strips for contamination, foreign
objects and contact pressure
Replace
x
10.4
Check rotor bearing play, out-of-balance and
lateral trueness
x
10.5
Check drive device
x
10.6
Check minimum and maximum turning speed
x
10.7
Check through the range of control
x
10.8
Check turning direction
x
10.9
Check motor bearing
x
10.10
Check electrical connections
x
10.11
Check gear mechanism leak-tightness
x
10.12
Check v-belts Re-tension, shorten or replace
x
10.13
Check regulating device control display function
x
10.14
Check water drain and siphon for function Cleaning and repair
x
11 Plate heat exchanger
11.1
Check Plate heat exchanger and evtl. droplet
separator for contaminants and damage
Clean with compressed air or high- pres-
sure cleaner (only water, without addi-
tives), carefully remove contaminated
water
x
11.2
Remove any dry dust and fibre material at the
exchanger intake
Remove with vacuum cleaner As required
11.3 Check condensation drain and siphon Cleaning und evtl. nachfüllen x
11.4 By kitchen extract air
Remove oil and grease residue from
kitchen extract air with hot water and
grease-dissolving cleaning agents
As required
12 Coil heat exchanger
12.1
Check pumps for damage, attachment, function
and noise
x
12.2
Check fixtures for damage, leak-tightness and
function
x
12.3 Check dirt collector screen for damage Cleaning x
12.4
Check pipeline system for damage, leak-tightness
and attachment
x
12.5 Check fluid level Refill x
EN.SILVER.110322
The company reserves the right to make design changes without prior notice.
www.swegon.com 29