©2018 SwellPro All Rights Reserved
32
When flying in ATTI mode, there are no Geofence Limitations.
Pre-Flight Inspection and checks
1. Please ensure there is sufficient charge in both the drone and the controller batteries.
2. Please check that the propellers are correctly installed.
3. Make sure the Micro SD card is properly inserted into the camera, and the sealing hatch is
securely fastened.
4. Please check that the Camera & gimbal are working correctly.
5. Please make sure the camera lens is clean.
6. Please verify that the motors can be started
Accelerometer calibration
Calibration is necessary in any of the following cases:
1. First time use of the drone.
2. Following sustained flight in ATTI mode.
3. If, when pushing up the THROTTLE joystick, without moving the right (AIRLERON) joystick,
and the drone drifts at an angle, while in GPS mode.
4. If the drone has been subjected to heavy shaking during transportation.
5. If, following a successful compass calibration, the motors do unlock, but the red LED stays
on solid when trying to start up the motors.
Home Point
Maximum flight
radius: 500meter
Maximum flight altitude: 200meter
To Next Page
Loading...
