SERVICES
39
WATER SYSTEM
On Arrival at the campsite /
Priming the system
• Ensure that the external water container
is full. An umbilical hose with baffle is
supplied with your caravan to connect
between the inlet and aqua roll or similar
container.
• Close all of the taps (kitchen sink, bathroom,
shower) except one, which should be open
in the hot position.
• Ensure that the water heater drain valve is
closed (move the Yellow handle on the floor
near the water heater to a
horizontal position).
• Switch the pump on using the button on the
control panel. Water will flow through the
open tap after a short time. This tap can then
be moved to the cold position and again
after a short time water will flow.
• Repeat the procedure at each tap, including
the external shower point
(model specific)
• When using a mains water connection
the pump will still need to be switched on to
supply water to the water heater,
taps and shower.
• If a mains water connection is used, please
ensure this is a Whale Watermaster mains
water hook-up, which has a built in pressure
reducing valve.
• To drain / winterise the system please see
separate details later in this handbook.
Whale Water In Socket and Watermaster®
exterior water pump with Easi-Push Plug
(when fitted)
To use the water inlet:
1) Fill an external water container, and position
the container near the Whale water inlet on
the side of the caravan.
2) Slide the lid upwards, by gripping the sides
of the lid, as shown on the image below:
3) Place the hose and filter supplied with the
caravan, into a full water container
4) Insert plug into water inlet and slide lid down
to lock plug in place as shown in the image
below:
Opening sliding lid
Back to section menu
To Next Page
Loading...
