FITTED EQUIPMENT
96
Maintenance and cleaning
Thetford recommends an annual inspection
service by an approved service centre.
Between annual servicing, clean the appliance
regularly after use. Before any cleaning work is
started, the appliance should be have been left
to cool and be disconnected from the gas and
electrical supplies.
• Always remove any spills or contamination
immediately after use with soap and hot
water. Towel dry the surface with a soft cloth.
• Use a non-abrasive multi-purpose cream
cleaner and a nylon scourer pad to clean
more stubborn dirt or grease.
• For routine cleaning of the glass surface, use
a cleaning cream and clean cloth or paper
towel. After cleaning, wipe dry with a dry
paper towel.
! WARNING: Do not use abrasive
cleaners, metal scouring pads or hard
brushes. They could damage the appliance.
! WARNING: If you clean the burner rings,
ensure that the holes are not clogged.
Note: The control knobs can be removed
for cleaning. The knobs are easy to replace.
Gas leaks
As soon as you smell gas:
• Ensure that all burners are turned off.
• Extinguish all naked lights and do not
smoke.
• Shut off the gas supply at the gas bottle
immediately.
• Do not use electrical switches.
• Open all doors and windows.
! WARNING: LPG is heavier than air.
Escaping gas accumulates at lower levels.
By following the strong, unpleasant smell of
gas, you can determine where the leak is
located. To investigate where it is exactly,
use a special leak detection spray. Never
use an open flame to find the leak!.
HOB
Back to section menu
To Next Page
Loading...
