Fitted Equipment
55
Product Indent. No: CE-0085AP0325
Automatic Ignitor
Power consumption: 50 MA (ignition)
0.01 MA
(monitoring)
Operating voltage: 3V
CHANGING OF BATTERIES
Changing the Batteries on the Automatic
Ignitor
Only change the batteries with the heater
switched off.
Always insert new batteries at the beginning
of the heating season.
Unclip front of heater, slide up battery cover
to reveal battery. Change the batteries.
Observe plus/minus.
Only use temperature resistant (+70°C), leak-
proof Mignon round cells (LR 6, AA, AM 3,
Art. no. 30010-23600). Other batteries could
lead to malfunctions!
TRUMA ULTRAHEAT
ADDITIONAL ELECTRIC HEATING
FOR TRUMATIC S 3002
OPERATING INSTRUCTIONS
Important:
Before operating the heater for
the first time it is essential to observe the
operating instructions enclosed with the
heater.
Switching on
Warning: Before switching on, ensure that
the fuse protection for the power supply of
the camp site is sufficient for the selected
power setting (b) (see Technical Data).
Important: The electric feed line for the
caravan must be fully unwound in the cable
drum.
1. Push slide switch (b) to the required
power setting.
2. Push slide switch (a) to the "ON" position.
3. Set rotary control knob (c) to the desired
room temperature.
The electric heater can also be operated
without the Trumavent fans.
If the heater is operated simultaneously with
electricity and gas, the electrical unit will
switch itself off before overheating occurs
as a result of the stronger gas burner.
a = Slide switch: ON - OFF
b = Slide switch
power settings:
500 - 1000 - 2000 W
c = Rotary control knob for room
temperature (illuminated by green
indicator lamp "operation")
Control panel with thermostat
To Next Page
Loading...
Need help?
General
