Swift caravan User Manual

Fitted Equipment
procedure in this position. Then position the
caravan horizontally and start the circulation
pump. Check that the pipes and radiators
around the vehicle are heating up.
Motor caravan or twin-axle caravan: The
easiest way to bleed the heating system is to
place the vehicle on a sloping surface or to
raise one end of the vehicle using a jack.
Bleed the system as described above.
SETTINGS FOR OPERATION OF THE
HEATING SYSTEM AND WARM WATER
HEATER
For more information on the settings on the
panel, please refer to the 'Control Panel'
section.
WARM WATER ONLY WITH 230 V
HEATING CARTRIDGE
1. Switch the circulation pump switch to
position (H).
2. Switch the LPG switch to position (E).
3. Switch the electric cartridge switch to
position (B).
(When the system is being used for warm
water only, the electronics limit output to
1kW, irrespective of the output actually
selected).
WARM WATER ONLY WITH LPG BOILER
1. Open the LPG shut-off valve.
2. Switch the circulation pump switch to
position (H).
3. Switch the LPG switch to position (F).
4. Switch the heating cartridge switch to
position (A).
HEATING AND WARM WATER WITH 230 V
HEATING CARTRIDGE
1. Switch the circulation pump switch to
position (I).
2. Switch the LPG switch to position (E).
3. Switch the heating cartridge switch to the
desired output position (B, C or D).
In the illustration, an output of 2100 W
has been selected.
4. Adjust the temperature to the desired
level (5-30°C) using the TPS control
thermostat (K).
HEATING AND WARM WATER WITH LPG
BOILER
1. Open the LPG shut-off valve.
2. Switch the circulation pump switch to
position (I).
3. Switch the LPG switch to position (F).
4. Switch the heating cartridge switch to
position (A).
5. Adjust the temperature to the desired
level (5-30°C) using the TPS control
thermostat (K).
62
A
B
C
D
E
FG
H
I

Swift caravan Specifications

General

Brand	Swift
Model	caravan
Category	Motorhomes
Language	English