Fitted Equipment
94
PULLMAN BUNKS
1. Release catches, one at a time.
2. Release press studs on the bed board.
3. Grasp the bunk as shown and pull
carefully in direction of arrows.
4. The bunk is designed to automatically
move into the correct position.
5. Where a bed board is fitted, unfold and
make sure it is secured by press studs
when lifted into position. (The bed board
is required to protect both the occupant
and the window from damage during use
of the bunk.)
6. Locate safety boards.
7. Arrange seat cushions as appropriate.
To Next Page
Loading...
Need help?
General
