ELECTRICS
79
No 12 volt output
from PSU
No 230v supply Check all above
Charger not switched on Turn charger switch on, switch will il-
luminate
Battery not connected and /
or charged
Install charged battery as per 3.4
Power button on control panel
not switched to on
Turn power on at control panel
Battery flat /
Battery fuse blown
Recharge battery, check fuses, check
charging voltage is present at battery
Fuse blown Check all fuses are intact and the correct
value fuse is installed as per fuse table
Equipment switched off /
unplugged
Check equipment is switched on and
connected to the 12v supply
PSU overheated / auto shut-
down operated
Reduce load on system. Allow PSU to
cool down. PSU will automatically restart
when cool.
Other fault Contact your Dealer
Pump not working Fuse blown Replace fuse with correct value as per
fuse table.
Pump turned off Turn pump on by pressing the pump
button at the control panel.
Setting incorrect Both the internal and external pump
feeds are controlled from the control
panel. To alter the setting of the pump
switch see section 3.8
Ensure the setting matches your desired
requirement.
3.13 Contact details
Sargent Electrical Services Limited, provide a
technical help line during office hours. Please
contact 01482 678981 if you require technical
help. For out of hour support please refer to
the tech support section of the Sargent web
site www.sargentltd.co.uk
To Next Page
Loading...
Need help?
General
