6
V. Mounting a camera attachment(only for Model SW380T)
Place the eyepiece adapter into the trinocular camera port on the top of the microscope
and mount an eyepiece camera (not included) directly on it. If you would like to use a C-
mount camera (not included), unscrew the top ring from the eyepiece adapter. You can
then use it as a 1X C-mount for the camera.
The parfocality between the eyepieces and the trinocular port has been preset before
shipment and should not need adjustment. If necessary, however, you can rotate the
parfocal ring in the eyepiece adapter to adjust the adapter height position and resulting
parfocality.
VI. Caring for your microscope
As with any quality instrument, your microscope should be stored in a cool, dry place.
Use the dust cover to protect the microscope when not in use. If necessary, clean the
lenses with a soft brush or compressed air to gently remove dust.
The specific operation is as follows：
To clean lens surfaces or filters, first remove dust using an air blower. If dust still
persists, use a soft/clean brush or gauze.
A soft gauze or lens tissue lightly moistened with the mixture of alcohol and ether
( ratio : alcohol : 3 and ether: 7) should be used to remove grease or
fingerprints.
Use only a mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) to
remove immersion oil from objective lenses.
Because the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) is
highly flammable, be careful handling around open flame.
To Next Page
Loading...
Need help?
General
