Switch-Pros SP9100 - User Manual

Rev 2.0 Jan. 2024
1
SP9100 8 Switch Programmable Switch Panel Power System
KEY INSTALLATION POINTS
Failure to follow installation instructions may affect warranty coverage.
1. Do not modify the Communications Cable, which connects the Switch Panel and Power Module.
• Why? The SP9100 uses specialty communication protocol that can be interrupted and malfunction if the
cable is altered in any way. For a custom length cable, please contact our Sales Department. For more
information, see Section 5.
2. The Light Blue Ignition Wire needs to be tapped into a 12V switched source.
• Why? When the Light Blue Ignition Wire senses 12V, the panel backlighting illuminates, and Ignition Input
switches are operational. To override the need for the Light Blue Ignition Wire, program switches to be
Battery Input. For more information, see Section 3.3.
3. Connect the Black Ground Wire directly to the negative terminal of the battery.
• Why? The negative terminal of the battery is the best ground source. A poor ground source can cause
abnormal behavior. For more information, see Section 3.2.
4. Do not connect any other power feeds to the stud on the Power Module.
• Why? The Power Module is not designed to support other equipment, beyond those that are powered by the
output wires. For more information, see Section 4.
5. Mount the Power Module in a vertical position, with the connectors facing outward, not upward.
• Why? This allows water to run off, and not collect on the top of the connector, or face of the module.
Pooling water can cause corrosion over time. For more information, see Section 2.
GET TO KNOW THE PARTS

Summary

KEY INSTALLATION POINTS

Do Not Modify Communications Cable

Prevents communication protocol interruption and malfunction.

Ignition Wire 12 V Requirement

Needs 12V switched source for backlighting and operation.

Ground Wire Connection Point

Connect to negative battery terminal for optimal ground.

Power Module Stud Restriction

Power Module Mounting Position

INSTALLATION

Switch Panel Mounting

Power Module Mounting

Mounting Location and Environment

16-Pin Output Harness Details

Output Wire Gauge and Amperage

Ground Wire Connection

Connect to the negative battery terminal for a secure ground.

Input Wire Connections and Functions

Ignition Wire Functionality

Connects to a 12V switched source for panel illumination and ignition functions.

Battery Cable Connection

Battery Cable Connection Steps

Connects Power Module to positive battery terminal with an in-line fuse.

PROGRAMMING AND APP CONNECTION

App Download and Bluetooth Connection

Steps for downloading the app and establishing a Bluetooth connection.

App-Based Switch Configuration Overview

Basic Switch Configuration Modes

Advanced Switch and LED Settings

Advanced Switch Modes (Strobe, LVD, Memory, Master)

Switch-Pros SP9100 Specifications

General

Number of Switches	8
Operating Voltage	12V DC
Maximum Total Current	125 Amps
Waterproof Rating	IP67
Communication Interface	Bluetooth
Features	Bluetooth control, customizable switches
Input Voltage Range	12-24 VDC
Operating Temperature Range	-40°C to 85°C
Maximum Amperage	125 Amps
Maximum Current per Output	20 Amps