sy.uk 8 V1.0
Cable Length: cat6 cable length between 20-70m is reported back
Link Status: Indicates the Transmitter/Omega3 units are intercommunicating correctly.
Signal Status: Indicates video signal activity on HDMI input / Output
Signal Error: Indicative of cat6 signal line quality
Input Signal details: Detailed information about the selected input video signals, such as:
Resolution, Refresh Rate, Colour Depth, HDR Setting, Compressed Audio Setting, Audio Rate,
Audio Channels, HBR and HDCP.
Pulse HPD: This command forces the HDP line low for 200mS, which has a similar effect as
HDMI cable disconnection/reconnection.
Voltage Value: Power supply voltage level measurement is reported.
Temperature Read: Internal temperature closest to the main heat source can be read. This
temperature will be higher than the device surface temperature.
CEC Commands
The following group of RS232 commands are only possible with display devices that support CEC
commands. Use the Error! Reference source not found. Connection Status RS232 command to
determine the CEC capability when the display device is fully powered.
CEC commands are most useful when it is not practical to use RS232 connection to the display.
Set Display to the ON state
Set Display into the standby state
Mute/Unmute sound volume (Toggle)
Display Connection Status
Get the current Connected/Disconnected info
Get the current display device power on/off info
To Next Page
Loading...
Need help?
General