6000 Watt Generator
Operation (cont’d)
Starting
1. Make sure that all tools and equipment to be powered by the generator are not plugged into the
unit while the engine is started.
2. Turn the Stop Switch on the control panel to its “ON”
position.
3. Open the fuel valve by turning lever to the “ON”
4. Close the choke lever by moving it left to the “START”
position (about ⅛ inch clearance).
5. Hold the start handle loosely and pull it slowly several times
to allow the gasoline to flow into the engine's carburetor.
Then hold the start handle firmly and pull the rope hard and
fast. Pull the rope all the way out using two hands if
needed. If necessary, repeat several times until the
engine starts.
6. Allow the engine to run for several seconds. Then, open
choke all the way.
© 2006, Sycamore SCS, LLC.
30
To Next Page
Loading...
