Battery
Compartment
Door
9v Battery
Remote Control
Handset
Check Remote Control Transmitter (Handset) CODE switch
settings are identical to Receiver CODE switch settings (use point
of ball point pen to adjust switches).
Note:
Remote Control Transmitter may vary from one shown.
Install Battery as shown.
If you are using a Wall Controller, skip these steps and go to Page 26.
IF THERE ARE ANY PROBLEMS DURING INSTALLATION OF THE FAN, THE INSTALLER MUST CONTACT THE
HUNTER PACIFIC INTERNATIONAL WARRANTY LINE . TEL: 1300 360 280BEFORE LEAVING THE WORK SITE
Setting Code Switches for Remote Control Handset and Installing Battery
18
To Next Page
Loading...