Important Safety Precautions
2
LOCATION AND INSTALLATION REQUIREMENTS FOR YOUR FAN
MECHANICAL ISSUES
To provide adequate clearance from the floor the lowest point on the fan blade must be at least 2.1m (7’)
from the floor.
Note: For a fan mounted directly to the ceiling, the lowest point of the fan blade is approximately 365mm
(14 ½”) below the ceiling.
Make sure that the chosen location of the fan will not allow the rotating fan blade to come into contact with
any object.
Ensure ceiling joists are sound and of adequate size and strength to support a 35Kg (77lb) load.
To reduce the risk of fire, electrical shock or personal injury, ensure that the fan mounting bracket is
supported directly from the building structure. DO NOT mount to an outlet box.
The mounting bracket must be firmly screwed to a load bearing structure e.g. a concrete ceiling, steel
structure or timber frame. If a timber frame is to be added it must be securely nailed or screwed between
two beams.
Do not remove the fan from the ceiling after installation.
Do not attach the Fan Blade before the Fan Motor Housing is installed and secured. To protect the finish,
the Fan Blade and the Fan Motor Housing should be kept in their cartons until ready to be installed.
After the fan is completely installed, check to make sure that all connections are secure to prevent the fan
from falling and/or causing damage or injury.
To reduce the risk of personal injury, do not bend or damage the motor Drive Shaft or Fan Blade when
handling or installing them.
IF THERE ARE ANY PROBLEMS DURING INSTALLATION OF THE FAN, THE INSTALLER MUST CONTACT THE
HUNTER PACIFIC INTERNATIONAL WARRANTY LINE . TEL: 1300 360 280BEFORE LEAVING THE WORK SITE
To Next Page
Loading...