6
Supplied Accessories
Owner's Manual Quick Start Guide Registration card
Remote Control
(NH210UD)
Batteries
(AAA, 1.SV x 2)
TV base and 3 screws (M4 x 14)
If you lose the screws, please purchase N4 x 14 Ph IIps head screws
at your Iota store,
If you need to rep ace these accesser es, please refer to the part
No, wth the ustrations and call our to free customer support
ne found on the cover oftNs manua,
Vhm csrl _ ur/ve_s;{_ eY_oe con _,h to (pel_te ths un
Nake sure the component code on your universa i_mote control
is set to our brand, Ref<,r to the manual accompanying your
remote contl@l for more details,
We do not guarantee 100% interopel abilty with all universal
remote centre s,
Symbols Used in this Manual
7he following is the descr ption forthe symbols used n ths
manual, Description refers to:
:D gital]V operat on
:Analog / Cable ]V operation
If nether symbol appears, the operation s applicable to
both,
Attaching the Base
You must attach the base to the unt to have t as a table top
unit, Be sure the front and real" of the base match the propel"
direction, At least ?_people are requ red for these steps,
1 Check the text "FRONT" w_th "an'ow" on the Base's
bottom to ensure t is beng installed n the correct
direction, Spread a thick and soft cloth over a table as shown
at step 2, Place the main unit face down onto t, Make sure
not to damage the screen,
2. Insert ?_hooks under the
bottom of the main unt
into base holes, {shown by
an'ow 71)),then move the
base n the d tect on as
shown by an'ow @ until t
stops and the screw holes
are aligned, lake sure not to put the AC power cord
between the base and the unit.
3 Dive Ph Ilips head screws
into the 3 threaded holes
at the bottom of the base
until they are tight
Io _ , hove the b;!se from hs ul
• Unscrew the Phillips head screws in step 3,
After the scrcws sis removed, move the base in the opposite
d rcction as shown by an ow in step 2, then pul the base up toward
the rear of the unt, Be careful not to drop the base when you
remove It,
Note
When attachin£ the base, ensure that a screws are ti$htly fdstened,
If tl_e base is not propel ly attached, it could cause the unt to frill,
result n£ n njuries as well as damsde to the unt,
Nal<e sure to use a tabe vvl_ch can support the weight ofths unt
and s ar£er titan this unt,
lake sum tl_e table s n s stable !ocation,
When attaching the base, epsure that"FRONT" wth "an-ovv"
written on the bottom of the base is downward, If t's not
downward, the _ hooks don't fit into the base,
Mounting the Unit onYour Furniture
Screw this unt on your futnture t ghtiy using wood screw (not
supplied) in the hole at the bad< of the base as shown.
• Recommended sclsvv dimens on :3/16 x 3/4 nches(5,1 x ]0 ram)
rear of this unit
hole
To Next Page
Loading...
