Need help?Do you have a question about the Sym Fiddle II 125 AW12W and is the answer not in the manual?
General| Displacement | 124.6 cc |
|---|---|
| Transmission | CVT |
| Front Suspension | Telescopic fork |
| Rear Suspension | Unit Swing |
| Front Brake | Disc |
| Rear Brake | Drum |
| Front Tire | 110/70-12 |
| Rear Tire | 120/70-12 |
| Seat Height | 780 mm |
| Height | 1135 mm |
| Engine Type | 4-stroke |
| Fuel System | Fuel injection |
Outlines essential safety measures for operating and servicing the motorcycle.
Details critical procedures and cautions for motorcycle service and maintenance.
Specifies torque values for engine bolts and nuts during assembly/disassembly.
Specifies torque values for frame bolts and nuts during assembly/disassembly.
Provides systematic troubleshooting steps for common engine starting and running issues.
Outlines recommended maintenance intervals and tasks for optimal performance.
Procedures for checking and adjusting valve clearance when the engine is cold.
Guides on adjusting carburetor idle speed and emission levels.
Covers ignition timing checks and spark plug inspection/replacement.
Covers brake hose inspection, brake fluid levels, and bleeding procedures.
Details free play adjustment and confirmation for drum brake systems.
Procedures for checking engine oil level, oil replacement, and strainer cleaning.
Covers oil pump removal, disassembly, inspection, and re-assembly.
Details gear oil level inspection and replacement procedures.
Step-by-step guide for removing and installing the carburetor.
Procedures for carburetor installation, fuel level check, and idle speed adjustment.
Step-by-step guide for removing the engine, including electrical connections.
Steps for installing the engine, including safety and routing of cables.
Steps for removing the camshaft and inspecting its components.
Detailed procedure for removing the cylinder head.
Steps for disassembling the cylinder head, including valve spring removal.
Procedures for inspecting cylinder head flatness, valve springs, stems, and guides.
Methods for inspecting and servicing valve seats, including grinding.
Instructions for reassembling the cylinder head, including valve installation.
Steps for installing the cylinder head and camshaft.
Procedures for installing the camshaft assembly.
Procedure for adjusting valve clearance using a feeler gauge and specific torque values.
Step-by-step guide for removing the cylinder.
Procedures for removing piston rings and measuring clearances.
Instructions for installing the piston into the cylinder and cylinder onto the crankcase.
Covers driving belt removal, inspection, and installation.
Covers clutch/driven pulley disassembly, inspection, and replacement.
Procedures for checking and replacing bearings in the gear box.
Procedures for draining oil and removing the A.C. generator components.
Covers starting clutch removal, inspection, disassembly, and installation.
Step-by-step guide for disassembling the crankcase.
Procedures for inspecting crankshaft clearances, run-out, and bearings.
Instructions for assembling the crankcase, including chain tensioner installation.
Procedures for replacing brake fluid and bleeding air from the hydraulic system.
To Next Page
