1. GENERAL INFORMATION
1-9
Torque Values
Item Q’ty
Thread Dia.
(mm)
Torque Value
(Kgf-m)
Remarks
Cylinder head bolt
4 8 2.0-2.4
Valve clearance adjust nut
4 5 0.7-1.1
Apply oil to thread
Spark plug
1 10 1.0-1.4
L. Crankcase cover bolts
7 6 1.1-1.5
Crankcase bolts
7 6 0.8-1.2
Oil drain bolt
1 8 1.1-1.5
Oil strainer cap
1 30 1.3-1.7
Gear oil drain bolt
1 6 1.0-1.4
Gear oil inspection bolt
1 6 1.0-1.4
Transmission cover bolt
7 6 1.0-1.4
Flywheel bolt
1 14 5.0-6.0
Clutch driving plate bolt
1 28 5.0-6.0
Driving disc nut
1 12 5.0-6.0
Clutch outer cover nut
1 10 3.5-4.5
Transmission cover bolts
7 6 1.0-1.4
Stopper nut for engine hanger
bracket
1 8 1.8-2.2
Nut for engine hanger bracket
1 10 4.0-5.0
Bolt for engine hanger bracket
1 10 4.0-5.0
Engine mounting bolt
1 10 3.5-4.5
Front wheel shaft nut
1 12 5.0-7.0
Rear wheel shaft nut
1 14 11.0-13.0
Bolt for rear shock absorber (upper)
2 10 3.5-4.5
Bolt for rear shock absorber (under)
2 8 2.4-3.0
Bolt for steering rod
1 10 4.0-5.0
Front shock absorber
4 8 2.4-3.0
Brake arm bolts
2 6 0.8-1.2
Brake hose bolts
4 10 3.3-3.7
Bolt for brake caliper
4 10 3.0-3.5
Bolts for the lining guide pin
4 6 1.6-2.0
Brake disk bolts
7 10 4.0-4.5
Mounting screw for speedometer
cable
1 5 0.15-0.3
Muffler bolts
4 8 3.2-3.8
Mounting bolts for exhaust pipe
connection
2 7 1.0-1.2
The torque values listed in above table are for more important tighten torque values. Please see
standard values for not listed in the table.
To this chapter contents
To Next Page
Loading...
