What to do if Symbol DS4308 Barcode Reader does not decode bar code?
If your Symbol Barcode Reader isn't decoding barcodes, here's what you can check: * Make sure the scanner is programmed to read that specific type of barcode. * Verify that the barcode itself is in good condition and try scanning a known good test barcode of the same type. * Position the aiming dot directly over the barcode.
General| Decode Capability | 1D, 2D, PDF417 |
|---|---|
| Sealing | IP42 |
| Weight | 5.71 oz./162 g |
| Scanner Type | Handheld |
| Corded Technology | Corded |
| Storage Temperature | -40° to 158° F / -40° to 70° C |
| Humidity | 5% to 95% RH, non-condensing |
| Scan Pattern | Omnidirectional |
| Connectivity | USB, RS232, Keyboard Wedge |
| Drop Specification | Withstands multiple 6 ft./1.8 m drops to concrete |
| Operating Temperature | 32° to 122° F / 0° to 50° C |
| Light Source | 650 nm laser diode |
| Minimum Bar Width | 4 mil |
| Resolution | 4 mil |
| Power Requirements | 4.5 to 5.5 VDC Host Power |
To Next Page
