DOC06501_Revision F
ATS-6501 Users Guide
71
Appendix B Status Command Fields
This section provides information on the results from the status command
ATS-6501>status
[alarm] no alarm Current alarm list
[fan] Fan Status
[1] true true = Running
[2] true false = Off
[gps] GPS Status
[auto_positioning] Auto Position Status
[time_remaining] 7 hours, 39 minutes Time left to determine position
[mode]
[desc] tracking Not Tracking/Tracking
[value] 4 Diagnostic value
[model] GPS Receiver Information
[hw_version] OEMV3G-4.00-X2T Model #
[name] L12LV Receiver frequencies
[serial_number] DAB08190113 Serial #
[sw_version] 3.400 Firmware Version
[position] Current Position
[alt] 4.8305500000000002e+01 Ellipsoid Height
[fixed] false Auto position information.
[lat] 3.8466278665490002e+01 Latitude
[lon] -7.7440859995379995e+01 Longitude
[satellite] Satellite Information
[number] 7 Number of satellites tracked
[signal]
[avg] 4.5854572296142578e+01 Average signal strength
[desc] Good Signal Quality
[enum] 2 Diagnostic value.
[freq] dual Tracking L1 only (Single) or L1/L2
[max] 4.9664001464843750e+01 Maximum signal strength
[min] 3.7810001373291016e+01 Minimum signal strength
[hardware] Hardware Status
[mainboard] System Mainboard
[EUID] 00:30:96:02:00:00:00:f6 Electronic Unit ID
[serialnum] SP00253 Serial Number
[type] 4370A-140 Mainboard Rev.
[outputs] System Outputs
[enabled] true True =On, False = Off
[slots] Output Cards
[1] Slot #1
[ports] Port Status
[1] Port #1
[status] good Good/Bad.
[2] Same for Ports 2-4
[status] good
[3]
[status] good
To Next Page
Loading...
Need help?
General
