Symmetricom Time Server User Manual

D-112 TimeVault™ User’s Manual 6000-100AppD.fm Rev. D
Appendix D: SNMP – Simple Network Management Protocol Symmetricom SNMP Enterprise MIB
TrueTime DEFINITIONS ::= BEGIN
IMPORTS
MODULE-IDENTITY, OBJECT-TYPE, Integer32
FROM SNMPv2-SMI
CounterFROM RFC1155-SMI
DisplayStringFROM SNMPv2-TC
TRAP-TYPEFROM RFC-1215;
--iso OBJECT IDENTIFIER ::= { 1 }
org OBJECT IDENTIFIER ::= { iso 3 }
dod OBJECT IDENTIFIER ::= { org 6 }
internet OBJECT IDENTIFIER ::= { dod 1 }
private OBJECT IDENTIFIER ::= { internet 4 }
enterprises OBJECT IDENTIFIER ::= { private 1 }
trueTimeEnt OBJECT IDENTIFIER ::= { enterprises 1896 }
TrueTime MODULE-IDENTITY
LAST-UPDATED “9906190000Z”
ORGANIZATION “TRUETIME INC.”
CONTACT-INFO “Technical Support”
DESCRIPTION “TrueTime Enterprise MIB”
::= { trueTimeEnt 0 }
trapMsg OBJECT IDENTIFIER ::= { trueTimeEnt 1 }
ntp OBJECT IDENTIFIER ::= { trueTimeEnt 2 }
ntsControl OBJECT IDENTIFIER ::= { trueTimeEnt 3 }
gps OBJECT IDENTIFIER ::= { trueTimeEnt 4 }
acts OBJECT IDENTIFIER ::= { trueTimeEnt 5 }
trapMsgColdStart OBJECT-TYPE
SYNTAX DisplayString (SIZE (0..255))
MAX-ACCESS read-only
STATUS current
DESCRIPTION
“This is an ASCII string sent to UDP port 162 (or user defined) when
the TrueTime time server reinitializes. The message is Cold Start Trap
PDU from: ###.###.###.###. Where ###.###.###.### is the doted
decimal notation of the IP address of the booting unit.”
::= { trapMsg 1 }
trapMsgNtpAlarm OBJECT-TYPE
SYNTAX DisplayString (SIZE (0..255))
MAX-ACCESS read-only
STATUS current
DESCRIPTION
“This is an ASCII-string sent to the UDP-trap port 162 (or user defined)
when the TrueTime time server’s detects change of the NTP-status. This
could be due to a line breakage in the timing source, loss of GPS
satellites, etc. The message is ‘NTP Status aaaaaaaa’, where aaaaaaaaa can
be NTP UNLOCKED, NTP client mode or NTP LOCKED.”
::= { trapMsg 2 }

Symmetricom Time Server Specifications

General

Brand	Symmetricom
Model	Time Server
Category	Network Card
Language	English