Symmetricom Time Server

To Next Page

To Previous Page

4-72 TimeVault™ User’s Manual 6000-100Ch4.fm Rev. D

Chapter 4: Serial or Telnet I/O Functions Extended Function Commands

Configuration of SNMP Parameters Using FTP

By default, SNMP is disabled. To use it, or to configure any other SNMP parameter using

FTP and a text editor, follow the steps outlined below. However, it is much faster and

easier to do this remotely, using the web interface (see “Remote SNMP Configuration” on

page 3-38). During this process, the FTP software creates a default configuration file

(“snmp.conf”) in your directory to hold the data you have requested. Do not change the

name of this file.

1. Send a “get” command:

Sample Entry: F100 config get snmp host:192.168.1.14

dir:temp

The unit responds:

Source file /config/snmp.conf bytes read: 1274

Dest File temp/snmp.conf bytes written: 1274

Configuration files transferred successfully

An example “snmp.conf” file might look like the following, with each string

appearing as a single line on your display:

MIB=/config/ttmib.o,

GenTraps=NO,

sysContact=Symmetricom Inc. 707-528-1230,

sysName=TimeVault,

sysLocation=Santa Rosa CA 95407,

NAME=public,VIND=1,TRAP=YES,ACCESS=R,IP=192.168.001.230,

IP=192.168.1.129,IP=000.000.000.000,IP=000.000.000.000,ENDC,

NAME=private,VIND=1,TRAP=YES,ACCESS=W,IP=000.000.000.000,