1-7-2 T2127EA
2. Setting for CONTRAST, COLOR,
TINT, V-TINT and SHARP Data
Values
General
1. Enter the Service mode. (See page 1-7-1.)
2. Press [PICTURE] button on the service remote control
unit. Display changes "BRT," "CNT," "COL," "TNT,"
"V-TNT," and "SHP" cyclically when [PICTURE] but-
ton is pressed.
CONTRAST (CNT)
1. Press [PICTURE] button on the service remote con-
trol unit. Then select "CONTRAST (CNT)" display.
2. Press [CH. o / p] buttons on the service remote
control unit so that the value of "CONTRAST
(CNT)" becomes 90.
COLOR (COL)
1. Press [PICTURE] button on the service remote
control unit. Then select "COLOR (COL)" display.
2. Press [CH. o / p] buttons on the service remote
control unit so that the value of "COLOR (COL)"
becomes 58.
TINT (TNT)
1. Press [PICTURE] button on the service remote
control unit. Then select "TINT (TNT)" display.
2. Press [CH. o / p] buttons on the service remote
control unit so that the value of "TINT (TNT)" be-
comes 56.
V-TINT (V-TNT)
1. Press [PICTURE] button on the service remote
control unit. Then select "V-TINT (V-TNT)" display.
2. Press [CH. o / p] buttons on the service remote
control unit so that the value of "V-TINT (V-TNT)"
becomes 56.
SHARP (SHP)
1. Press [PICTURE] button on the service remote
control unit. Then select “SHARP (SHP)” display.
2. Press [CH. o / p] buttons on the service remote
control unit so that the value of “SHARP (SHP)”
becomes 48.
Note: BRIGHT data value does not need to be adjust-
ed at this moment.
To Next Page
Loading...
