Synesso MVP - Plumbing and Electrical Connections


11
PLUMBINGREQUIREMENTS
Thisequipmentmustbeinstalledtocomplywiththeapplicablefederal,stateorlocalplumbingcodes.
WATERTREATMENTISREQUIREDTOPRESERVETHEFULLMACHINEWARRANTY.Pleaseensurethatthe
incomingwatercomplieswiththewarrantyrequirementslistedonpage7.
Usingtheprovidedstainlesssteelbraidedhose,connectthepump
totheshutoffvalveonthefilteredcold
waterline.Fingsonthehosesandpumpsare3/8”tubecompression.ThreadsealantorTeflontapeis
notnecessary.Makeconneconssnug,butdonotoverghten.
TurnincomingwaterONandcheckforleaks.
Synesso™machinesrequirea
minimumof50PSI(3.5bar)oflinepressureat30gal(120L)perhourtohave
theauto‐fillsystem,forthesteamtankfunconingproperly.Pleaseensurethattheincomingwatermeets
thisrequirementorcontactSynesso™foralternavemethodsofboosngwaterpressure.
NOTE:Synesso™sellsa“Euro‐hose”adaptorhoseandfing(partnumberis1.5020)whichconvertsfroma
3/8”tubefingtoapipefing,suitableformostnon‐USplumbing.Pleaserefertothepicturebelowto
idenfythedifferencesbetweenthestandardandEuro‐stylefingsandhoses.

1/4”NPT
3/8”TubeCompression
3/8”BSPPipe
Standard Fing ‐ #1.5620
Standard Hoses ‐
48” #1.5060
84” #1.5070
Euro Hose ‐ #1.5010
Euro Fing ‐ #1.5000
(Euro Assembly ‐ #1.5020)
