29
PROGRAMMING
Firmware Updates:
The machine’s rmware is the basis for all of its programming features as made available by the handheld
controller. Synesso provides updates to the rmware as needed in order to make improvements to the func-
onality of the machine. Firmware updates require access to the electrical box and main electronics board
of the machine and must be performed by a qualied technician.
S Series machines run o of rmware versions 2.xx, starng with version 2.59 and proceeding up unl the
current version 2.64 (as of 2020). If the machine is running o of an older rmware version and you would
like to update to the current version—so as to make certain features available and receive the most improved
machine funconalies—please have a qualied technician reach out to Synesso Technical Support. One of
our technicians can provide the latest rmware and instrucons needed to perform the update.
The rmware that is currently installed on the machine can be viewed on the start-up screen of the handheld
controller when powering the machine on (see picture below).
This start-up screen appears momentarily when the machine power is cycled on. The rmware can be
viewed in the upper right corner of the screen, in this case v2.59.
To Next Page
Loading...
Need help?
General
