1 QSG f201 version 2.1
Firestar™ f201 laser & Flyer 3D System Quick Start Guide
1. Lift the Flyer 3D Marking Head out of the box only by the middle; do not use housing, coolant ttings,
or anything else on the sides to lift the laser.
Important
Note:
See the Flyer 3D Marking Head and Firestar f201 Laser Operators Manual for complete
installation details and instructions. A PDF version is available Online at:
http://www.synrad.com/Manuals/manuals_laser.htm.
Marking Head Unpacking:
Attention:
For complete details, refer to the Getting Started (System Inventory and Mounting)
Sections in the Firestar f201 and Flyer 3D Marking Head Operator’s Manual.
Read all Danger, Warning, Caution terms, symbols, and instructions located in the (Laser Safety
Hazard information) sections in the Flyer 3D Marking Head and Firestar f201 Laser Operation Manuals.
Caution
Correct
1.1 Lifting the Marking Head correctly by holding in the middle.
1.2 Avoid mis-alignment risk! Do not use housing tting or fan (as shown) or any thing on
the side to lift.
To Next Page
Need help?
General
