机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 16
•
•
•
•
•
•
•
•
The items in the folder will show on workinglist
Check the sequence is corresponding to the panel.
Execute the process.
BarCode Scanning Mode
Press The "Normal Mode" button, change to "Scan Mode", Press again back to "Normal Mode".
Scan the barcode and the scanned NCfile will be added to workinglist by sequence, if no files
found in system, there will show a pop-up hint
Figure
ScanMode
Scaning Barcode and add to Workinglist
Set Repeat Times for the Same File
The default of repeat time is 1, every time the process done, it will minus 1 time.