Syntec 60CB - Page 44

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 44
d.
•
•
e.
•
•
f.
i.
ii.
iii.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Absolute input:
Press【A】and press【Enter】
The value of where the cursor is located will be set as the "input value".
Incremental input:
Press【I】and press【Enter】.
The value of where the cursor is located will be set as "input value" + "current cursor
value".
Measure input:
Press【Z】and press【Enter】, the value of where the cursor is located will be set as the
current Z-axis "relative coordinate" value.
Press F2 Set Tool Mach. Coord., the tool length compensation value of where the cursor is
located will be set as current Z-axis "machine coordinate" value.(valid version from 2.2.0)
Press F3 Set Tool Rel. Coord., the tool length compensation value of where the cursor is
located will be set as current Z-axis "relative coordinate" value. (valid version from 2.2.0)
Clear Z Coord.
Path
F3 Offset/Setting → F2 Tool Set → F1 Clear Z Coord.
Function
Clear the current Z-axis relative coordinate value.
Tool No.
Path
F3 Offset/Setting → F2 Tool Set → F7 Tool No.
Function
Please refer to chapter 3.4.4 for details
Tool Life Manag.
Path
10+8 key: (Right column) Offset/Set → F2 (Tool Set) → F8 (Tool Life Manag).
8 key: F3 Offset/Setting → F2 Tool Set → F8 Tool Life Manag.
5 key: F3 Offset/Setting → F2 Tool Set → F5 Tool Life Manag.
Function
Please refer to chapter 3.4.5 for details