机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 85
1.
2.
3.
4.
•
•
•
•
•
•
•
•
•
•
•
Prepare an app with 2D bar code scanning function. (The apps showed on the
controller screen are recommended. )
Scan 2D bar code and the controller information will be uploaded to the customer
service request page.
Fill in the required information.
Press “Save” to send the information and press “Finish” to leave the screen on the
controller.
Note
When the controller information is too much to display in one bar code, two or more bar codes
will be created. When scanning, the system will also remind the users to scan the remaining bar
codes.
If two or more bar codes are created, the code number will be shown on the screen like
[1/2] and [2/2], also “Next” and "Previous" buttons can be used to switch.
The hotkeys on the operation panel will be disabled when applying the online service action.
System Permissions
Serial No. Setting
Path
5 key: F5 Maintain → Next → Next → Next → F5 About → F4 System Permissions →F1 Ser. No.
Setting
8 key: F5 Maintain → Next→ F8 About → F7 System Permissions → F1 Ser. No. Setting
10+8 key: G8 System →F10 About → F4 System Permissions → F1 Ser. No, Setting
Explanation
Can be used to set the system serial number
Please ask the original manufacturer for the setup password
To Next Page
Loading...