N200-25-00 13 I56-2424-04R
cedure. If the detector still fails the test it should be
returned for repair.
NOTE: For the FSB-200S, the external power supply must
be connected for the test switch to work.
Maintenance
NOTE: Before cleaning the detector, notify the proper
authorities that the smoke detector system is undergoing
maintenance, and therefore the system will be temporar-
ily out of service. Disable the zone or system undergoing
maintenance to prevent unwanted alarms.
1. Carefully clean the outer housing lens face. A damp soft
cloth with a mild soap may be used. Avoid products with
solvents or ammonia.
2. Carefully clean the reflector. A damp soft cloth with a
mild soap may be used. Avoid products with solvents or
ammonia.
3. Notify the proper authorities that the system is back on
line.
Painting
The outer aesthetic ring may be painted using a spray or
brush type paint of appropriate type. See specification sec-
tion of this manual for paint types.
NOTE: Never paint the flat lens surface of the outer
housing.
Special Note Regarding Smoke Detector Guards
Smoke detectors are not to be used with detector guards
unless the combination has been evaluated and found suit-
able for that purpose.
To Next Page
Loading...
Need help?
General
