23 De-installation / Dismantling
WARNING
Hazard from electrical voltage
› Switching off and de-installation only by a trained electrician or trained and instructed qualied personnel.
› Pay attention to the 5 rules of electrical engineering:
– clear (all-pole separation of an electrical system from live parts)
– secure against switching on again
– establish freedom from voltage
– earth and short-circuit
– cover or fence off neighbouring live parts.
" Disconnect all electrical lines carefully.
" Separate the Multibox and the supply connections.
CARE
Hazard from blows and cuts.
› Wear protective gloves when dismantling.
› Dismantle carefully.
" Remove the tting material carefully.
" Place the Multibox on the oor.
24 Disposal
Both the device and also the transport packaging comprise recycling-capable raw materials to a great extent.
24.1 Disposing of the Multibox
If the Multibox is to be nally dismantled and disposed of, proceed as follows:
" Switch the Multibox free of voltage.
" Separate the Multibox and the supply connections.
" Dismantle the Multibox into its component parts.
" Separate the parts resulting from this according to
– reusable components
– material groups to be disposed of (metal, plastic, electrical part etc.)
" Ensure that the parts are recycled again. Pay attention to the national directives.
24.2 Disposing of packaging
" Ensure that the parts are recycled again. Pay attention to the national directives.
49
Multibox MUB - V 1.0
De-installation / Dismantling
To Next Page
Loading...
