Installation and configuration |
3
established. Reset the SAVE CONNECT
module to default settings and try again.
See chapter 3 Resetting to default set-
tings, page 5.
4 Once the SAVE CONNECT module is connected to the
wireless router, it will automatically establish connec-
tion with the Cloud server (it should not take longer
than 1 minute). The LED will continue blinking once per
second in green colour.
Proceed to chapter 5 First login to SAVE CONNECT ap-
plication for login instructions.
2.3 Wi-Fi connection setup using a control panel
If your wireless router does not support WPS, Wi-Fi connection should be set up manually.
Therefore you need to find Wi-Fi name and add password using control panel.
1. In control panel go to Service -> Communication -> WLAN settings menu.
2. Press Scan for networks button. The SAVE CONNECT module will search for avail-
able Wi-Fi networks (should not take longer than one minute).
3. After search is complete, find the network name to which the SAVE CONNECT module
should connect and select it. Wi-Fi network must be password protected.
4. After required Wi-Fi name selection, password pop-up window appears in control panel
screen. Insert your Wi-Fi network password.
5. If password is correct and connection to Wi-Fi network is successful, the SAVE CON-
NECT module will establish connection to Cloud server automatically. The SAVE CON-
NECT module LED will start blinking slowly in green colour.
Proceed to chapter 5 First login to SAVE CONNECT application for login instructions.
2.4 Wi-Fi connection setup using a mobile application
Note:
Location and Storage permissions have to be enabled for SAVE CONNECT
application.
If previously described connection methods are not available – Wi-Fi settings can be set
up using the Mobile Application.
254977 | v6
To Next Page
Loading...
