SystemAir SAVE Series - SAVE VSC 100 Filter Replacement; Filter Replacement Steps for SAVE VSC 100; SAVE VSR 150;B Filter Replacement; Filter Replacement Steps for SAVE VSR 150;B

PAGE 3
1
SAVE VSC 100
2
SAVE VSR 150/B
3
SAVE VSR 300/500
When it’s time to change the shown on the control panel
display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
1. Stop the unit by disconnecting the mains.
2. Remove the lter cover plates.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Remount and fasten the lter cover plates and
connect the unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Remove the lter cover plates.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Remount and fasten the lter cover plates and
connect the unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Open and remove the side cover.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted. See note above.
5. Replace and lock the side cover and connect the
unit to mains.
6. Reset the lter time.