SystemAir SAVE Series - SAVE VTR 250;B Filter Replacement; Filter Replacement Steps for SAVE VTR 250;B; SAVE VTR 300;B Filter Replacement; Filter Replacement Steps for SAVE VTR 300;B

PAGE 5
7
SAVE VTR 250/B
8
SAVE VTR 300/B
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
1. Stop the unit by disconnecting the mains.
2. Open the front hatch.
3. To remove the supply air lter loosen the knobs to
remove the lter lock (image shows when lter is hidden).
Only one of the lter locks needs to be removed.
Wiggle the lter and pull it out.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Close and lock the front hatch and connect the
unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Open the front hatch.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Close and lock the front hatch and connect the
unit to mains.
6. Reset the lter time.
1
2
3
4